Quick Jump Start Guide

Posted by Smart Motors | Posted in Automotive, Car Care, Car Maintenance, Driving, Service, Winter Driving | Posted on 18-12-2013

Tags: , , ,

0

Your vehicle’s battery is responsible for starting your vehicle, as well as powering a variety of electrical accessories. An alternator recharges your battery while the vehicle is running, but your battery may become drained for a variety of reasons, including extreme temperatures, leaving lights on, or simply old age. No matter what the reason, a dead battery can leave you stranded, and frustrated. If you believe the battery is the culprit of your car-starting woes, follow these simple steps for a successful jump start.

Boost_Park

1.     Park the booster vehicle close but not touching the vehicle that needs to be jumped. Once in position, shut off the booster vehicle.

 

2.     Begin the process by clamping one of the positive jumper cable ends (red) to the positive battery terminal (labeled with a “+” on the battery) of the dead vehicle.

 

3.     Connect the other end of the positive cable (red) to the positive battery terminal on the booster vehicle (again, confirm that a “+” is next to the battery terminal).

 

Boost_Compartment

4.     Connect the negative cable end (black) to the negative battery terminal on the booster car (marked with a “-“). Finally, attach the other end of the negative cable to an unpainted metal surface on the engine of the dead car.

 

5.     Start the booster vehicle and allow it to idle for about 1 minute before attempting to start the dead vehicle.

 

6.     Start the dead vehicle and let the two vehicles idle for a few minutes.

 

Boost_Order

7.     Once the dead vehicle is started and running smoothly, disconnect the jumper cables in the reverse order that they were connected.

 

8.     Drive the revived car to somewhere safe and secure before shutting off the engine.

Note: If the dead vehicle is not starting after  a few attempts, check all connections and reposition if necessary. You may also need to let the booster vehicle idle for up to 5 minutes while connected to the dead vehicle, in order to reach an adequate charge.

 

 

Share this:
Facebook Twitter Linkedin Digg Delicious Stumbleupon Email

Click here to submit your review.


Submit your review
* Required Field